Skip to content

Remove word that was incorrectly repeated twice. #710

New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Merged
merged 1 commit into from
Nov 24, 2019
Merged

Remove word that was incorrectly repeated twice. #710

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
2 changes: 1 addition & 1 deletion Language/Variables/Constants/constants.adoc
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -74,7 +74,7 @@ Digital pins can be used as `INPUT`, `INPUT_PULLUP`, or `OUTPUT`. Changing a pin
Arduino (ATmega) pins configured as `INPUT` with link:../../../functions/digital-io/pinmode[`pinMode()`] are said to be in a _high-impedance_ state. Pins configured as `INPUT` make extremely small demands on the circuit that they are sampling, equivalent to a series resistor of 100 Megohms in front of the pin. This makes them useful for reading a sensor.
[%hardbreaks]

If you have your pin configured as an `INPUT`, and are reading a switch, when the switch is in the open state the input pin will be "floating", resulting in unpredictable results. In order to assure a proper reading when the switch is open, a pull-up or pull-down resistor must be used. The purpose of this resistor is to pull the pin to a known state when the switch is open. A 10 K ohm resistor is usually chosen, as it is a low enough value to reliably prevent a floating input, and at the same time a high enough value to not not draw too much current when the switch is closed. See the http://arduino.cc/en/Tutorial/DigitalReadSerial[Digital Read Serial^] tutorial for more information.
If you have your pin configured as an `INPUT`, and are reading a switch, when the switch is in the open state the input pin will be "floating", resulting in unpredictable results. In order to assure a proper reading when the switch is open, a pull-up or pull-down resistor must be used. The purpose of this resistor is to pull the pin to a known state when the switch is open. A 10 K ohm resistor is usually chosen, as it is a low enough value to reliably prevent a floating input, and at the same time a high enough value to not draw too much current when the switch is closed. See the http://arduino.cc/en/Tutorial/DigitalReadSerial[Digital Read Serial^] tutorial for more information.
[%hardbreaks]

If a pull-down resistor is used, the input pin will be `LOW` when the switch is open and `HIGH` when the switch is closed.
Expand Down