diff --git a/content/hardware/10.mega/boards/giga-r1-wifi/tutorials/cheat-sheet/cheat-sheet.md b/content/hardware/10.mega/boards/giga-r1-wifi/tutorials/cheat-sheet/cheat-sheet.md
index 0888fc49aa..504feb3c50 100644
--- a/content/hardware/10.mega/boards/giga-r1-wifi/tutorials/cheat-sheet/cheat-sheet.md
+++ b/content/hardware/10.mega/boards/giga-r1-wifi/tutorials/cheat-sheet/cheat-sheet.md
@@ -289,6 +289,8 @@ The pinout for the display connector is shown in the image below:
 
 ![MIPI/DSI connector.](assets/mipi-dsi.png)
 
+***When connecting a module or shield to the GIGA R1 WiFi board, be careful to not connect it at an angle or your board may be damaged.***
+
 The following pins are directly connected to the STM32H747XI and cannot be used as GPIOs.
 - D1N
 - D1P
diff --git a/content/hardware/10.mega/shields/giga-display-shield/tutorials/01.getting-started/getting-started.md b/content/hardware/10.mega/shields/giga-display-shield/tutorials/01.getting-started/getting-started.md
index 7b4f6b57a8..98ff6a30e0 100644
--- a/content/hardware/10.mega/shields/giga-display-shield/tutorials/01.getting-started/getting-started.md
+++ b/content/hardware/10.mega/shields/giga-display-shield/tutorials/01.getting-started/getting-started.md
@@ -100,8 +100,11 @@ To use the GIGA Display Shield, mount it on the **bottom** side of the GIGA R1 W
 
 ![Bottom View](assets/mounted.png)
 
+
 This makes it possible to freely use the GIGA R1 WiFi's pins while the display shield is connected.
 
+***When connecting a module or shield to the GIGA R1 WiFi board, be careful to not connect it at an angle or your board may be damaged.***
+
 ## Camera Connector
 
 Located on the top side of the shield is a 20 pin camera connector, which is Arducam® compatible and supports a wide range of cameras. The connector is connected to the [GIGA R1 WiFi's camera connector](/tutorials/giga-r1-wifi/giga-camera#camera-connector), and is compatible with a wide range of cameras ([see Arducam cameras](https://www.arducam.com/camera-for-arduino-giga/)).