Fix typos

Author: marqdevx

content/hardware/04.pro/miscellaneous/wisgate-edge-pro/tutorials/pole-mounting/content.md

@@ -36,8 +36,7 @@ The mechanical pieces are included with the device, those will make the device f
 
 Turn the gateway, on the back it has four holes for screws, align those with the bracket and screw them.
 
-The bar from the bracket should be on the aiming towards the top, where the antennas are connected.
-
+The bar from the bracket should be closer the top, where the antennas are connected.
 
 <iframe 
   width="720" 
@@ -49,7 +48,7 @@ The bar from the bracket should be on the aiming towards the top, where the ante
 
 ### Clamps on the Pole
 
-Take the bigger clamp and introduce one screw on the hole that fits better for your pole, grab the smaller clamp and align it with the screw, after that you should take a nut and make it closer to the smaller clamp, repeat it with the other side, first just make sure everything is aligned and then fasten them properly with a screwdriver.
+Take the bigger clamp and introduce one screw on the hole that fits better for your pole width, grab the smaller clamp and align it with the screw, after that you should take a nut and make it closer to the smaller clamp, repeat it with the other side, first just make sure everything is aligned and then fasten the nuts with a washer properly with a screwdriver.
 
 ***The clamp is also suitable to be mounted using hose clamps (not included) you should then use the rectangular holes on the bigger clamp***
 
@@ -64,7 +63,7 @@ Take the bigger clamp and introduce one screw on the hole that fits better for y
 ### Attaching the Bracket on the Clamps
 
 Once both the bracket on the gateway and the clamps on the pole are properly fasten, it is time to attach the gateway to the pole.
-After it's attached fasten one M6*12 screws on each side.
+After it's attached fasten one M6*12 screw on each side.
 
 As shown in the following video: