Datasheet: Update related products

Author: marqdevx

content/hardware/04.pro/carriers/portenta-breakout/datasheet/datasheet.md

@@ -51,6 +51,9 @@ This product is designed to work alongside the Portenta family. Please check the
 
 ### Related Products
 *   Arduino Portenta H7 (SKU: ABX00042)
+*   Arduino Portenta H7 Lite (SKU: ABX00045)
+*   Arduino Portenta H7 Lite Connected (SKU: ABX00046)
+*   Arduino Portenta X8 (SKU: ABX00049)
 <!-- *   OpenMV Global Shutter Camera Module -->
 
 ### Solution Overview
@@ -123,6 +126,15 @@ The DIP switch allows for boot mode configuration:
 *   **BOOT SEL**: When set to ON, keeps the Portenta in Boot mode.
 *   **BOOT**: When set to ON enables the embedded bootloader. Firmware can be uploaded via the USB port on the breakout board (DFU). USB-A to USB-A  (non-crossover) cable required. The Portenta H7 has to be powered through the USB-C connector or VIN.
 
+### RJ-45 Connector
+The RJ-45 Connector allows to plug ethernet cables and connect to your net.
+
+By default it is compatible with the **Arduino Portenta H7** as the jumper pads are joint with copper.
+
+To **allow** compatibility with the **Arduino Portenta X8** it is needed to cut 2 jumper-pads, located on top of the to the RJ-45 Connector, below the SD holder, on the left side of the Carrier as show in the following picture.
+
+![Ethernet Jumper pads](assets/breakoutCarrierEthernetSolderJumpers.svg)
+
 ## Board Operation
 **Note:** This board is intended to operate together with Portenta H7 (see section 1.4 Solution Overview).