diff --git a/examples/lis3dh_simpletest.py b/examples/lis3dh_simpletest.py
index 7b96cdc..89de0fa 100644
--- a/examples/lis3dh_simpletest.py
+++ b/examples/lis3dh_simpletest.py
@@ -12,13 +12,14 @@
     lis3dh = adafruit_lis3dh.LIS3DH_I2C(i2c, address=0x19, int1=int1)
 else:
     i2c = busio.I2C(board.SCL, board.SDA)
-    int1 = digitalio.DigitalInOut(board.D6)  # Set this to the correct pin for the interrupt!
+    int1 = digitalio.DigitalInOut(board.D6)  # Set to correct pin for interrupt!
     lis3dh = adafruit_lis3dh.LIS3DH_I2C(i2c, int1=int1)
 
 # Hardware SPI setup:
 # spi = busio.SPI(board.SCK, board.MOSI, board.MISO)
-# cs = digitalio.DigitalInOut(board.D9)  # Set to appropriate CS pin!
-# lis3dh = adafruit_lis3dh.LIS3DH_SPI(spi, cs)
+# cs = digitalio.DigitalInOut(board.D5)  # Set to correct CS pin!
+# int1 = digitalio.DigitalInOut(board.D6)  # Set to correct pin for interrupt!
+# lis3dh = adafruit_lis3dh.LIS3DH_SPI(spi, cs, int1=int1)
 
 
 # Set range of accelerometer (can be RANGE_2_G, RANGE_4_G, RANGE_8_G or RANGE_16_G).
diff --git a/examples/tap.py b/examples/tap.py
index 8078db4..014bba8 100644
--- a/examples/tap.py
+++ b/examples/tap.py
@@ -15,6 +15,12 @@
     int1 = digitalio.DigitalInOut(board.D9)  # Set this to the correct pin for the interrupt!
     lis3dh = adafruit_lis3dh.LIS3DH_I2C(i2c, int1=int1)
 
+# Hardware SPI setup:
+# spi = busio.SPI(board.SCK, board.MOSI, board.MISO)
+# cs = digitalio.DigitalInOut(board.D5)  # Set to correct CS pin!
+# int1 = digitalio.DigitalInOut(board.D6)  # Set to correct pin for interrupt!
+# lis3dh = adafruit_lis3dh.LIS3DH_SPI(spi, cs, int1=int1)
+
 # Set range of accelerometer (can be RANGE_2_G, RANGE_4_G, RANGE_8_G or RANGE_16_G).
 lis3dh.range = adafruit_lis3dh.RANGE_8_G